9/23/2023 0 Comments Seagate seatools dos commands![]() ![]() Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again. If the drive is on a controller card then it is possible that the set drive size command may not work. 2 IMPORTANT This is a special DOS bootable CD-ROM. Make sure the drive is connected directly to the motherboard and not to a third-party controller card. SeaTools for DOS User Guide Copyright © 2011 by Seagate Technology, LLC. If a message in red displays, then an error occurred. Remove the SeaTools diskette/CD, power off the computer for a few seconds, then reboot and check the capacity of the drive again in the BIOS. If you get an OK message in white in the middle of the screen, then the process was successful. Click the "R - Reset to Maximum" button.Click "C - Set Capacity" at the top of the screen.If this is not the current drive, click the "D - Drive" button in the upper left until you see the drive you want to test displayed in the middle of the screen. The model number of the drive currently selected is displayed here. You can see what device is selected by looking in the middle of the screen. 2.Double-click Win32DiskImager.exe to launch 'Win32 Disk Imager' which we use to create the bootable USB disc. zip (Filehosting Mirrors : 8.3 MB) and extract to desktop. Look at the bottom portion of the window to see what drives are listed and what device number they are. Okay, here are some instructions that might be helpful in this case. Now choose the drive for which to set the size.This is usually used to find and repair bad sectors. Long test - Runs a full scan of the drive. If DST is not supported by the drive, Seatools runs a read test. Click "I agree" to the license agreement. Under the Basic menu: Short test - Runs a DST test against Seagate drives. ![]() Once booted from the SeaTools for DOS diskette or CD, the computer should display a screen with a license agreement. 137GB or 32GB) and it is a computer that should support a drive that large, then this would be a time to set the drive size. For example, if the drive is showing up as a smaller capacity in the BIOS (i.e. Sometimes it is necessary to use the SeaTools for DOS software to get the drive back to its native capacity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |